CellSol Arduino Repeater Pylon Kit



Expand the Network with Arduino Repeater Pylons
The Arduino Repeater Pylon is a low cost CellSol pylon designed for mass deployment. Its main function is to forward messages along the network, extending the overall range for more complex pylons. This version of the kit does not contain a bluetooth module. If you need one, please purchase the bluetooth version instead.
Kit Contents
- CellSol Pylon Circuit Board
- Arduino Nano
- Battery control board
- LoRa radio module
- 100mil headers (for everything else)
- 2mm headers (for the radio)
- jumper (for turning it on and off)
- 4.7k Ohm Resistor
- Filter Capacitor
- Voltage Regulator, 3.3v
- antenna wire, 85mm
- battery wires
- battery case, 3xAA
- solar panel

CellSol - A Network for Unity and Resilience
Robots Everywhere is proud to partner with the CellSol Project to provide a disaster-resistant last-mile solution to keep communication channels open even when the wider Internet is unavailable.
Please see their website for more information about CellSol, including assembly instructions for your kits, and how to set up your pylons.