From Research Paper to Working Hardware in Two Months
Rapid scientific instrumentation prototyping for a NASA-related research project
The Challenge
In July 2026, Robots Everywhere was presented with a scientific paper published in 2016. Among its future research objectives was a request for a bespoke sensor capable of AC excitation of a salt substrate for studying extremophile bacteria.
The paper described a research need, but fulfilling it required turning that need into actual hardware.
The sensor would have to operate in extreme environments ranging from Antarctica to Death Valley, to match the bacteria it is intended to study.
The Solution
In August, we designed and tested a custom sensor to meet the project’s requirements.
With the initial design established, we moved into small-batch production in September, manufacturing the first run of 20 sensors.
During this process, the team performed debugging and iterative refinements before handing off the completed batch.
The sensor itself is designed to be customizable by grad students using the Arduino IDE with no external libraries.
Further Development
In October, following delivery of the initial sensors, Robots Everywhere was asked to develop a second version.
As of October 28, 2026, the revised design is ready for another fabrication run.
The Results
Within approximately two months, Robots Everywhere took a scientific research requirement through design, prototyping, testing, and delivery of an initial production run.
The project demonstrates our ability to move quickly from specialized scientific requirements to physical instrumentation, incorporating engineering feedback and design revisions without lengthy development cycles.
Project status: Version 2 ready for fabrication, October 2026.
It’s good enough for NASA. We’re betting that it will be good enough for you.
